New Rotor rubbing on inside shield - photos
#1
New Rotor rubbing on inside shield - photos
Hi there, I recently replaced my front rotors and pads on my 2007 XL 2.3, once I reinstalled the rotor I found it was rubbing against the inside shield. Not the braking surface itself but the radially slotted piece that is on the inside of the rotor, rubbing an extended piece of metal. (not sure its purpose...air movement?)
I reused the seal and bearings, as they were practically new, and the other side which I changed is not having this problem. Any ideas? Did I over-tighten the bearing adjustment nut?
photos: Imgur: The most awesome images on the Internet
I reused the seal and bearings, as they were practically new, and the other side which I changed is not having this problem. Any ideas? Did I over-tighten the bearing adjustment nut?
photos: Imgur: The most awesome images on the Internet
Last edited by P_Smith; 05-22-2017 at 12:10 PM.
Thread
Thread Starter
Forum
Replies
Last Post
DallyBoy09
Snapshots
40
12-22-2009 06:33 PM