ranger reverse is fine but engine stall when shifted to drive, 1st or 2nd
Thread Starter
|
Member
Joined: Apr 2024
Posts: 1
Likes: 0
From: GOSNELLS
ranger reverse is fine but engine stall when shifted to drive, 1st or 2nd
Hi everyone I have a 2013 PX1 3.2 4x4 Ranger with AT transmission, it reverse is fine but engine stall when shifted to DRIVE, 1st or 2nd gear(engine still stall even rev up the rpm before shifting) happened especially when engine warm, would be worse when up hill, can drive when down hill but needed shift to neutral let the wheel roll up a bit then shift to drive after 20miles/h everything normal until next stop. After this happened I did transmission service(ATF, filter changed), tried disconnected the transfer case plug or transmission solenoid plug in order to forced it to limit mode but still has same issue.
It has no engine light or transmission light come on, so nothing comes up on scan tool.
Is anyone got the same issue, any suggestions or anything I can check?
Thanks.
It has no engine light or transmission light come on, so nothing comes up on scan tool.
Is anyone got the same issue, any suggestions or anything I can check?
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
