i was wondering where i can find a new rear diver side panel mines all bent up cuz my tire fell off and messed it up. and i was seeing if u guys can help me locate one,

 

What? Rear quarter panel? No such thing exists on a ranger.
If you are talking about the bedside, I would recommend just buying a new bed and putting that on your truck. Instead of hacking it up to bits and pieces and bondo-ing a new bedside on.

 

Like Alex said you should just get a new bed. In order to fix yours its a lot of cutting and bondo-ing the smashed part.

 

bedsides arent hard to put on at all...hell you dont need any bondo if you do it right

 

well, if its damaged like i think it is then its all in the wheel well.
so you end up cutting out the whole wheel well section, inside the bed most likely. and the outside. depending on how messed up it is.

 

yea good point

 

Alright I think I'll just go with finding a bed for it. Any ideas where to look like online?

 

Craigslist.
http://www.car-part.com/
Ebay.