hey guys, quick question, couldnt find it by searching. whats the sequence for linking a brand new remote unlock/lock thingy? thanks

 

Unlock the doors with the switch on the door. Then cylce the key from off to run eight times ending in the run position. The locks should cycle to signal that you are in programming mode. Then press any button on EVERY remote that you are programming, even those that are already programmed.

 

Place the key in the ignition and turn from 2 (LOCK) to 3 (OFF) and cycle between 3 (OFF) and 4(ON) eight times in rapid succession (within 10 seconds) with the eighth turn ending in the 4 (ON) position.

The doors will lock/unlock to confirm that programming mode has been entered.

Within 20 seconds, program a remote transmitter by pressing any button on a transmitter. The doors will lock/unlock to confirm that the remote transmitter has been programmed.

(If more than 20 seconds pass before pressing a remote transmitter button, the programming mode will exit and the procedure
will have to be repeated.)

Repeat the previous step to program additional remote transmitters. The doors will lock/unlock to confirm that each remote transmitter has
been programmed.

When you have completed programming the remote transmitters, turn
the ignition to 3 (OFF). Again the doors will lock/unlock to confirm
programming has been completed.

 

thanks!

 

got a remote for my truck in the mail the other day, took me ten minutes to remember to leave key in on position after the eighth cycle, works fine now, exactly like the two above have said