ignition cylinder
#1
#2
I had the same exact problem when I got my tilt column from the junkyard. The easiest way is to take a chisel/flat head screw driver and just start breaking the cylinder apart (be careful not to damage the column, especially the part around the cylinder). Eventually you will get to the part where you can pull most of it out. But you will most likely leave the tip on it in. You can see how this tip looks by pulling the one in your vehicle out. You will need to take some needle nose pliers and turn the tip till it is released.
This is the way I did it. Took about 30 mins. Just be careful.
I forgot to mention that you hit the screwdriver with a hammer (duh).
This is the way I did it. Took about 30 mins. Just be careful.
I forgot to mention that you hit the screwdriver with a hammer (duh).
#4
I have a pretty good (yeah I'm modest) how to on how to replace the column:
http://tinyurl.com/steeringcolumnswap
http://tinyurl.com/steeringcolumnswap
#8
#12
Thread
Thread Starter
Forum
Replies
Last Post
The S-10 Killer
General Technical & Electrical
4
06-27-2009 12:20 PM