As my long title says I have a 2004 xlt with factory fogs in the lower valence. The little piece that covers the light inside has fallen off so I need to open the lights up. Obtook them off the truck and can't open them. I heard on here somewhere thabyou may need to pit them in the oven. Can anyone help with some pointers. I don't want to ruin them and also want to make sure they seal good after cuz right now they leak and get water inside. Thanks guys

 

I havent looked around, but buying a used or new one, cant cost that much.

 

You would be surprised!

 

yea there pretty pricey and these are in good shape other than that inner thing.

 

I had the same thing happen this past summer-I used a Dremel wilth a cutoff wheel to separate the lens from the housing. Just take your time and sneak-up on it a little bit at a time.
MikeR

 

And you used the dremel where they come together right?

 

Yup- went at the seam between the clear lens and the black housing.
MikeR

 

ehhh not ready to do that i threw them in the oven and could only get one open so i stopped lol