Did a M5OD manual swap from a 4R44E auto. I was able to snag a computer and an engine wiring harness for a 2.5L manual 2wd. I’m trying to wire up the clutch pedal position switch into the cab side wiring harness. However upon looking at the EVTM’s between 1998-2000 it shows a clutch pedal position switch “jumper” underneath the driver side dash. I’ve looked all over and cannot find anything remotely close to what is described in the diagrams or by others on the forums.

I want the neutral safety circuit to function as it would from a factory manual. As well as the engine/speed controls. Anyone have any ideas or pictures of what I should be looking for? Is there another circuit I could pull from for pins 1-2/3-4/5-6 on the clutch pedal position switch? Thank you in advance.