wiring help after 1998 ranger auto to manual swap
Thread Starter
|
Member
Joined: Apr 2011
Posts: 2
Likes: 0
From: ontario
wiring help after 1998 ranger auto to manual swap
Hi everyone . I just did a tranny swap from auto to manual on my 1998 ranger and i cant find the wires i need to get by the neutral safety switch. i have no red with a light blue strip wire on the tranny connector... can anyone plese help me?
Member
Joined: Nov 2005
Posts: 767
Likes: 4
From: Elizabeth City, NC
Connect the Pink wire to the Tan wire with a red stripe.
You can find those two wires at the old connector to the DTRS (neutral safety switch that WAS on the transmission shifter shaft).
The best repair is to get a harness from a manual shift truck and replace that section and add the clutch pedal switch.
Welcome to Ranger Forums!
You can find those two wires at the old connector to the DTRS (neutral safety switch that WAS on the transmission shifter shaft).
The best repair is to get a harness from a manual shift truck and replace that section and add the clutch pedal switch.
Welcome to Ranger Forums!
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: Wiring harness 04/05 manual wiring harness
Cody.mckinley
OLD - Interior, Exterior, Electrical, & Misc.
0
Oct 14, 2013 02:28 PM
Bojagalo
General Ford Ranger Discussion
5
Jun 28, 2013 12:22 AM
04blackedge
OLD - Interior, Exterior, Electrical, & Misc.
1
May 7, 2009 04:43 PM
