Hi... Need help splicing new o2s conector to harness Bank 2(passenger side) sensor 1 .


Thanks Marco

 

Welcome to the Herd! Lots of friendly knowledgable folk in these forums.
Exhaust OxSensors on 2002 Ranger V6~4.0L~SOHC are located as pictured below:
~ Bank1Sensor1 @ Upstream RghtPassengerSide
~ Bank2Sensor1 @ UpStream LeftDriversSide
~ Bank1Sensor2 @ DnStream CommonCatConvertor
Make sure you're NOT changing the wrong OxSensor?
Assuming you're installing a "Universal" OxSensor that
has only a 4WireCable without a Plug & needs to be ButtSpliced to old OxSensor Cable?
What brand is the new OxSensor; hopefully Bosch or MotorCraft, so that wire colors are same as original factory sensor?

 

Thanks for the info....my new sensor is motor raft, problem is I'm missing conector from harness side , wires from new plug don't match the harnesses

 

Below is the Harness~Cable WireColor info I have for my 2001 SportTrac V6~4.0L~SOHC;
suspect it's the same for your 2002 Ranger V6~4.0L~SOHC, but can not guarantee that.
Either Heater WhiteWire on each Sensor can be connected to 12v, it works either way.
Again this is for MotorCraft\Bosch OxSensors; other brands can have different colors.
Hopefully this helps. Click here for more information on NarrowBand4Wire OxSensors.

OxSensor11@RghtManifold
* SensorBlk/Blk~HarnessOrg/Org = Signal+ From 12v PowrFuse?? ??a
* SensorGra/Gra~HarnessGra/Blu = Signal- Into PCM Pin60 0.1~0.9v
* SensorWht/Wht~HarnessBlu/Org = Heater+ From 12v PowrFuse?? ??a
* SensorWht/Wht~HarnessRed/Wht = Heater- Into PCM Pin93 0.2~3.0a
OxSensor21@LeftManifold
* SensorBlk/Blk~HarnessOrg/Org = Signal+ From 12v PowrFuse?? ??a
* SensorGra/Gra~HarnessRed/Blk = Signal- Into PCM Pin87 0.1~0.9v
* SensorWht/Wht~HarnessBlu/Org = Heater+ From 12v PowrFuse?? ??a
* SensorWht/Wht~HarnessYel/Blu = Heater- Into PCM Pin94 0.2~3.0a
OxSensor12@RearCatCnvtr
* SensorBlk/Blk~HarnessOrg/Org = Signal+ From 12v PowrFuse?? ??a
* SensorGra/Gra~HarnessRed/Gra = Signal- Into PCM Pin35 0.1~0.9v
* SensorWht/Wht~HarnessBlu/Org = Heater+ From 12v PowrFuse?? ??a
* SensorWht/Wht~HarnessWht/Blk = Heater- Into PCM Pin95 0.2~3.0a