General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

2008 Ranger speaker connectors in dash

Thread Tools
 
Search this Thread
 
Old Apr 3, 2021
  #1  
dhosh's Avatar
Thread Starter
|
Member
Joined: Apr 2021
Posts: 7
Likes: 0
From: Alanson, Mi
2008 Ranger speaker connectors in dash

I have 2 connectors behind the radio slot: I believe the current after market radio was connected to the right connector, with nothing connected to the left one . What is the left one used for?


 
Reply
Old Apr 3, 2021
  #2  
RonD's Avatar
RF Veteran
iTrader: (1)
Joined: Jan 2014
Posts: 30,635
Likes: 2,952
From: Vancouver, BC
Welcome to the forum

You need to look at wiring color

2008 wiring below
Base model had amp in head unit
Deluxe had separate amp

 
Attached Files
File Type: pdf
2008 audiophile.pdf (14.9 KB, 275 views)
File Type: pdf
2008 base radio.pdf (10.0 KB, 321 views)
Reply
Old Apr 3, 2021
  #3  
dhosh's Avatar
Thread Starter
|
Member
Joined: Apr 2021
Posts: 7
Likes: 0
From: Alanson, Mi
Thanks!
THIS diagram matches the color / connector layout on the connector in the dash. I assume it must have plugged directly into the radio. I can now match up the new radio's pigtail to the male connector pigtail in the plug kit.

Thanks!

Dennis
 
Reply
Old Apr 3, 2021
  #4  
RonD's Avatar
RF Veteran
iTrader: (1)
Joined: Jan 2014
Posts: 30,635
Likes: 2,952
From: Vancouver, BC
Just as a HEADS UP
DO NOT USE the Green/orange stripe wire AT ALL on a Non-Ford radio............did I mention, DO NOT USE the wire from FUSE 22!!!!

That is the MUTE TO START 12volt wire, it only has 12v when key is turned to START position, that would MUTE the Ford Radio
If you were to wire that to a 3rd party radio for power then when you turn the key to ACC or RUN the starter motor would come on............lol, but not funny when it happens

So MARK IT as DO NOT USE, if you cut it then tape the end or cap it so it can't short



 
Reply
Old Apr 3, 2021
  #5  
dhosh's Avatar
Thread Starter
|
Member
Joined: Apr 2021
Posts: 7
Likes: 0
From: Alanson, Mi
I had imdeed3d planned on NOT using it.. and just working it to the run/acc position... But hadn't considered the consequences if I HAD! Thanks for the tip to tape it off and tag!
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Ranger_Dad
General Ford Ranger Discussion
10
Jan 9, 2023 12:14 PM
420stackz
Audio & Video Tech
9
Dec 7, 2019 05:23 PM
HoboNinja
General Technical & Electrical
3
Aug 15, 2015 02:46 PM
rangerwillie
Audio & Video Tech
1
Sep 24, 2008 05:46 PM
Boriqua_02~EdGe~
General Technical & Electrical
7
Apr 5, 2006 09:07 PM




All times are GMT -6. The time now is 01:48 AM.