Is there anyway to replace the wires that go from the doors to the 'cab' like the ton of wires that let you work the windows etc? I think there's a 'plug' inside the door panel, but I'm not too sure. Since I've cut my wires to take my doors off, I want the wires to be back to normal? Can anyone point me in the right direction?

Brenton

 

yeah, there sure is a way.. I bought them last summer when I did my power windows/locks install, they cost me about $150 or so each at the dealer.. and took a couple of weeks because they had to be made in the philippines.. I'd check the junkyards first, you should be able to score it for less than $50

 

just solder and heat shrink everythin do it right dnt make the connect outside the door like it is..run new ones so it gets on the inside so its outside from the weather

 

ask ranger 1 for new wires...

 

oh even better!!!

you buy em brenton we can work something out and ill help you install

 

I'm bringing this thread back to life!

I see on the passengers side that there's a huge plug to where all the wires from the power window switches and stuff plug into behind the kick panel... BUT, where in the heck do all the wires on the drivers side door panel go to?

Brenton

 

Nevermind, I just found the d-side plug. This is going to be WAY easier than I thought.

Brenton