Hey everyone,

On the tailgate of my ranger the dealer's logo emblem is mounted...However it is literally chipped in half.

What is the easiest way to remove those types of emblems? Without damaging the paint, etc.?

Thanks guys!

 

Pin stripe removal wheel.

 

WD-40 and Goo Gone work well for me. Heat gun helps to loosen the glue up

 

I used braided fishing line to remove my emblems. No heat need colder the better actually....

 

I think he's talking about the little decal the dealers stick on your car in the lot. Not the actual emblem.

 

pressure washer

 

3M eraser wheel is by far the best to get off a decal or the double sided tape left over from an emblem.

 

x2, I used one of those for removing the tape left over from emblems and hood scoops, took me about 5 minutes to do what took about 2 hours by hand

 

I used a blow drier and goo gone. It worked, used both those things to remove my pin stripes too.

 

I'm actually talking about like an emblem. The dealership sticks their dealer emblem on the back of the truck and it is similar to the Ranger emblem

 

Just get something under a corner of it enough that you can grab it. Then just pull. That is how I got my Ranger emblems off and had no problems.

 

Hair dryer works. It needs about 10 min but there is a hole under it so put something there.

 

Heat gun and fishing line works good for me.

 

Paint stripper... DISCLAIMER: Will also take paint.






lol but yeah a hair dryer would work or Goo Gone.

 

heat gun and something really thin and sharp to break the adheasive and then something to pry up with