Looking for some ideas to clean up the engine bay some. I have wires running all over the place. Mainly would like something out of the way that I can wire all my wires into and not make a clusterf*** on my fusebox terminals or battery terminals.

So what ideas can you share? Or what are you using currently? I was looking at maybe one of the battery terminal splitters used for audio set-ups, but I am not running any subs/amps so not sure that would work since I don't have any 4 gauge being run.

 

get that plastic wire covering and use that you will be surprised how fast it cleans up the engine bay

 

yea the split loom, problem is the wires are going in all different directions...

 

i have the same problem in my truck take a picture of it might be able to come up with some better ideas for you if i have something to look at

 

It isn't too bad yet, but it will be getting worse when I start getting the mods done to the shell. Right now just off road lights and CB. Probably have at least 3 more headed that way in the near future.

 

I have the same problem right now, I think I'm just going to get one of those things for the battery terminal you said and use that. I need to pull all my wire out and run it in split loom too.

 

Yay for tedious wire looming in the near future!!! grr