When we loaded my truck on the trailer i just used the starter to crank the engine over and pull it self up onto the trailer..

about half way up i was like huh, i wonder if it'll start up just for ****s and giggles.. nothing

it just cranked and cranked..


I haven't really had a chance to get in there and look around and see what was going on with everything.

if the computer got fried it wouldn't do anything right?
and could the air hammer trip the inertia switch? i don't really think so but a few friends do, asking cant hurt


Any Suggestions?

 

You can check the inertia switch. it should be in the passanger side kick panel (I believe).

 

ya that was on my list for today.

 

yeah man it could trip the switch. but if the computer was fried it would still spin over. what was going on when it quit starting?

 

did you unhook the battery during all this welding?

fuel pressure up?

 

if you didnt disconnect the neg. terminal you might of fawked up the computer

the 1st thing you should do is disconnect it

hope its something else but good luck!

 

yea, the first thing i did was disconnect the battery as soon as i pulled it in, i was going to check fuel pressure when i got around to it.

 

well then id check for other loose items.