Hello everyone, I have a 94 Ranger. My turn signals suddenly quite working, but hazard lights all worked fine. I thought it must be the switch, when I detached the switch from steering column four wires came loose and where hanging. I think they came out of the turn signal connector which was partially melted. Not sure if they came loose before causing arching, or if came loose because of getting hot. I've tried researching to figure out what order they plug back onto the switch, but can't find anything. Their colors are Red with Orange strip, Red with Black strip, Green with Black strip, and Blue with Orange strip. All the new connectors I've found have all white wire pigtails.?? PROBLEM 1 Also after playing around with the multi switch, tried to put it back on to go to parts store and now I have no headlights, but taillights work fine. Any Help would be much appreciated. Sorry for rambling, my first time doing this.

 

My serious suggestion, grab another multifunction switch. Just get a good, clean one from a junk yard. And make sure you grab the flasher module with it. It fixed all my problems. And since you said it was partially melted, I'd say it had a short inside it. Don't repair it. Replace it