I have some factory power door locks that I want to put into my truck but am not sure what to wire them into? I have a remote start that has a lock and unlock function, the truck will beep once or twice for lock/unlock but obviously does not do anything. Is there somewhere i can run the wires from the lock that will make them work with my remote start?
thanks!

 

bump
anybody?

 

I hate to see a post go without a reply but I have never looked at the door locks to say how to.

What does the locks require for a signal to activate and deactivate the locks?

What signal comes from the Remote Starter ?

Another question is do you need a diode or something to stop the remote starter signal from entering the locks system in the vehicle ?

Too many question for me to give an answer but at least you get a bump...

ltr and luck,

 

Here's a factory wiring diagram for power locks. Hope it helps...