earlier post talks about and illustrates buckets to be added to my '94 ranger They will be replacing the bench.
The buckets I just found out are poser, drivers and passengers.
Whazzup with getting power to them?
Is it possible that the harness already has what's necessary?

 

Power seats just need positive and negative wires.

 

I thought the Ex Pwr Seats had three wire hook up ?

 

My 98 expo seats only had two words i ran a fused pos straight from the battery and its grounded under the seat with something else not sure what but it was a dedicated ground right under the seat. The draw from the seats is way to much to tap into anything in the cab already so its safer to run its own power line.

 

30 amps fuse 10gauge line then splice to the second seat with 14 is fine ground it to the seat bolt and it works fine

 

Don't forget the fuse close to the battery !