testing an ohc
#1
testing an ohc
Had a good day at Pick-n-Pull yesterday, got me an ohc and a domelight out of an expo,
both are in great shape, and the color of my interior (both for $28). Anyways my Question is that I tried to test the ohc, so I hooked up ground and power(not a good connection btw) and what happened is the ohc display came on and then turned back off, the display was garbled as well, is this normal? or is it because more wires need to be hooked up?
both are in great shape, and the color of my interior (both for $28). Anyways my Question is that I tried to test the ohc, so I hooked up ground and power(not a good connection btw) and what happened is the ohc display came on and then turned back off, the display was garbled as well, is this normal? or is it because more wires need to be hooked up?
#2
#3
Sorry, I failed to mention this was just a bench test also, my bad. anyway I got home from work yesterday, and hooked it up again, but when the screen went blank, I waited about three seconds and then it came back up and appeared normal, the day before I just unhooked the wire when it went blank, so I jumped the gun a little bit. I am assuming that it must come up all garbled like that and then re-set itself? I also hooked up power to the lamp and the temp sensor and it all appears to be working like it should, so hopefully the installation process will commence this weekend as I cant wait to get it installed, I am really stoked about it.
Thread
Thread Starter
Forum
Replies
Last Post
malydeen
General Technical & Electrical
9
05-01-2009 05:48 AM
V8 Level II
Suspension Tech
34
04-30-2006 10:00 AM