5 Speed and Sport Trac console..
#1
5 Speed and Sport Trac console..
Hey guys, i know ive saw people cut out the expo consoles and use them with a 5spd, i was curious if i am able to do this on the sport trac on as well, wasnt sure because the front pocket is slightly different, also if it is able to be done, will the Redline shift boot work?
Thanks guys!
Pic of console i have
Thanks guys!
Pic of console i have
#2
Old Guy User…
iTrader: (12)
Anything is possible IF you want to do it. Take your time, measure the Console that you know works, then see if you can cut something like it in yours.
As far as the Red Line Boots, nice stuff but I think you will need a complete custom setup which I think they do, don’t know, call them after you get the opening cut the way it needs to be.
As far as the Red Line Boots, nice stuff but I think you will need a complete custom setup which I think they do, don’t know, call them after you get the opening cut the way it needs to be.
#7
Old Guy User…
iTrader: (12)
Before you cut, that is if you haven't already, test fit whatever boot you will be using.
Measure the stroke of the shifter handle in each movement, 1 to 2, 2 to 3 and 3 to4 and side motion.
Start with finding the center of the shift movement, then center the boot and mark, cut small, fit the boot and see if the shifter works, then if necessary cut again.
Fit , cut, fit, cut, take your time and make it look good...
Measure the stroke of the shifter handle in each movement, 1 to 2, 2 to 3 and 3 to4 and side motion.
Start with finding the center of the shift movement, then center the boot and mark, cut small, fit the boot and see if the shifter works, then if necessary cut again.
Fit , cut, fit, cut, take your time and make it look good...
Thread
Thread Starter
Forum
Replies
Last Post
99offroadrngr
OLD - Interior, Exterior, Electrical, & Misc.
9
05-07-2010 11:50 AM
steev
OLD - Interior, Exterior, Electrical, & Misc.
11
01-14-2010 04:04 AM
Hillyard
OLD - Interior, Exterior, Electrical, & Misc.
1
08-30-2009 10:02 AM