Anyone relocated the jack and tools? On my 05 Silverado, I moved it over to the engine bay where the optional second battery would go. Where have you guys moved them too? Pics?

 

Why move it?

 

wanna build a custom box and its in the way

 

You might be able to squeeze it in the engine bay, but I doubt it. They are really cramped there.

The only other place that I can think of is either in the bottom of your center consle, under the seat or in your box

 

I relocated mine to my garage lol

 

It does look kinda cramped in the bay...I'll try to figure out a little spot for it.

ur lifted so that jack is probably useless anyways right?

 

ya i just got rid of it... no need for it

 

mines mounted in my bed. in front of my wheel well i had to cut the plastic cover a bit but whatever..

 

In my 03 extended 2 door no rear seats its in the side compartment under a plastic tray.

 

mine is located behind the jump seat (fold outftw)

 

in tool box on back wall

 

I went to harbor freight tools one day and picked up a cheap toolbox then put the jack in that. Afterwords i placed it in the bed of my truck which has a locking tonneau on it. I just used bungees to tie it to the side. Stays put and out of the way and can always take it out easily :)

 

I had the same problem when I was designing my enclosure so I just got rid of mine, damn thing was useless anyways. I just carry a small floor jack in the bed. And I replaced all the plastic back wall with 3/4" MDF that I carpeted.

 

move it into the other hole behind the jumpseat. or make your box for the other jumpseat