Overhead Console
Overhead Console
OK, So I am going to the wreckers on Friday to pullout an overhead console out of an explorer. Couple of questions:
1) What is the best way to remove it?
2) Where is the temp sensor on the explorer?
Thanks
1) What is the best way to remove it?
2) Where is the temp sensor on the explorer?
Thanks
1) Screw driver.... (sorry could not resist)
2) Behind the grill if I recall (been a while since I looked for one)
Just remember to save as much of the wiring as possible.. It make reinstalation much easier(as easy as taking a part from one veh and putting it on another can be...)
2) Behind the grill if I recall (been a while since I looked for one)
Just remember to save as much of the wiring as possible.. It make reinstalation much easier(as easy as taking a part from one veh and putting it on another can be...)
After you remove the two front screws, there are two "clips" that are just pushed in on the front. Once the two rear screws are out, just pull the front down hard and it will come off. Then there are two screws for the mounting bracket.
There's some pics of some of the stuff and some installation advice on my Cardomain site (link in my sig).
Edit: I should have said BACK screws -- as was mentioned they are under the door at the back end of the console.
There's some pics of some of the stuff and some installation advice on my Cardomain site (link in my sig).
Edit: I should have said BACK screws -- as was mentioned they are under the door at the back end of the console.
Last edited by n3elz; Mar 3, 2005 at 07:21 AM.
Originally Posted by FLPanther
1) Yup screwdriver for the 2 screws in the garage door compartment and the screws on the bracket
2) Behind the front bumper on the driver side is where I have seen them
2) Behind the front bumper on the driver side is where I have seen them
Thanks everyone.
I have actually already seen it, it is the one with the garage door opener. Sounds pretty easy. John, I have seen your How To on the cardomain site, and was impressd with it. I will be using that to help guide me through my installation!.
By the way, there is another overhead console at the wreckers, it is tan in colour and will have all the parts (wirng harness, mounting bracket, and most likely the temp sensor). If anyone is interested I can try and get that one too and sell it. Shipping might be a little high (I live in Canada), but could be negotiable.
Email me at quinnin@gmail.com if you are interested.
I have actually already seen it, it is the one with the garage door opener. Sounds pretty easy. John, I have seen your How To on the cardomain site, and was impressd with it. I will be using that to help guide me through my installation!.
By the way, there is another overhead console at the wreckers, it is tan in colour and will have all the parts (wirng harness, mounting bracket, and most likely the temp sensor). If anyone is interested I can try and get that one too and sell it. Shipping might be a little high (I live in Canada), but could be negotiable.
Email me at quinnin@gmail.com if you are interested.
Originally Posted by 00ranger00
i was wondering what years those consoles can be put in? i got a 2000 but a buddy has a 1996 and whats to do it. Is it possible?
https://www.ranger-forums.com/forum2...6782#post66782
Thread
Thread Starter
Forum
Replies
Last Post
ranger4.0
OLD - Interior, Exterior, Electrical, & Misc.
10
Feb 15, 2011 11:25 PM
TheBearJeweler
OLD - Interior, Exterior, Electrical, & Misc.
19
Jun 12, 2009 07:26 PM






