Plasti-dip on wheels?
Would it be possible for this mod to cause a highway vibration or shaking? I was driving about 75mph and I was getting a bad vibration from the rear... I know my axle is going but it wasn't a grinding sound it was like my wheel was about to fall off. Ideas?
I'd say it's POSSIBLE but I wouldn't thnk it would be too noticeable. as mentioned make sure your wheels are seated properly and tight. jack it up and spind the wheel see if you notice a wobble.
as for the bedliner I used it in my wheel wells, I usually spray it off with a hose and it comes clean. It has flaked of VERY little, and all I did to prep was a quick rough sand on the wheel well, didn't even wash them. I have a spare wheel, I might try it out on.
as for the bedliner I used it in my wheel wells, I usually spray it off with a hose and it comes clean. It has flaked of VERY little, and all I did to prep was a quick rough sand on the wheel well, didn't even wash them. I have a spare wheel, I might try it out on.
I agree 100% but I wasnt sure if I would like it on my truck, this is a good one to do to see if you like the look without wasting 500 bucks to powdercoat/mount&dismouint tires, the TPMS sensor BS etc.
Thread
Thread Starter
Forum
Replies
Last Post
04RangerDave
Interior, Exterior, & Electrical
21
Oct 1, 2013 10:58 AM





