Well my windshield wiper fluid isn't really working... I am almost positive that it's the connector.. looks like it melted/fried a little bit..

Is anyone going to the junk yard possibly grab this for me... or snip on off there?

I have a 2001 Ranger XLT

After reading I guess the ford Explorer uses the same thing as well.. I saw a post and a 99 explorer should work as well.

There are two connectors on the stalk. On is like a longer triangle connector and then there is the smaller one.

I need the smaller one:







It has 7 wires going to it.

If you are able to get one I ask that you can leave as much wire as possible... IE: Cut as far back as you can rather than at the connector.

Thanks much!

-Nigel

 

You should think about getting rid of the connector, if not, a new is really the best way.
I know money... but by the time you get a JY piece, clean it up and clean up the male side enough for things to work for a while you could have put in the Splices you were talking about in another thread or replaced with a new connector.

Chk prices on all option before you buy or decide the best way to handle it.

 

How would I replace this? Doesn't the harness go all the way to the engine... I was not aware this could be taken out completely.. it's so tight I can't pull any slack...

-Nigel

 

I can look for one for you on monday Nigel. I am hitting the yard then

 

I think I ended up getting one. Had someone drop me a PM that went to the junkyard today.

Thanks though!

Greatly appreacated.

-Nigel