Giving some love to the front :-D
Keith.. I think it's a gen 5 thing... You have the 5.5 I like to call it.. I think it was specific to 01-03 before the new grille...
Mike, LOOKS AWESOME MAN! I run mine on down at school... Cops are rump rangers and pull you over for nothing, it's gay lol
I dunno how WA cops are about that **** though, so just don't do anything wrong.. I know it's hard... lol
Mike, LOOKS AWESOME MAN! I run mine on down at school... Cops are rump rangers and pull you over for nothing, it's gay lol
I dunno how WA cops are about that **** though, so just don't do anything wrong.. I know it's hard... lol
Give me a bit, as I have a truckload of pictures, and a set of how-to pictures shane and i cooked up concerning speedo cluster and interchanging things.. including setting the speedo with a battery (works great, tested it on my rig after i did the cluster swap..
Edit: I think I'll hold off till tomorrow to get all these pictures resized and copied over to photobucket.. there are 170+, tons and tons to go through! lol
Last edited by WowMike2001; Aug 9, 2008 at 06:03 AM.
hmm....both trucks are '01's. both are 4.0L. both are manual trans. I've seen autos with and autos without them. my brother's '01 2.5 5spd doesn't have it either.
no channel...

with channel...

no channel...

with channel...
no channel...

with channel...

no channel...

with channel...
Man yeah, that interior shot is amazing!!
switched out my speedo cluster with a new one, lots more paint here and there, and pretty much kicked back and played around with random stuff on the back of his truck, lol.. lots of wiring and whatnot going on =)
Not too shabby. to secure it even more I think I will pull a Shne and get some angle irion to block the front of it.. that way no one can get a clamp around them to spin em.
Ohh speakin of that.. any luck looking at getting those extended brackets made by the way shane? Need to be about 2 inches wide, roughly an 8 inch piece bent around 3/4ths in with a 2 inch pipe bend
Should work perfect methinks.. looks sorta funny not being able to put them where they should be
lol
Ohh speakin of that.. any luck looking at getting those extended brackets made by the way shane? Need to be about 2 inches wide, roughly an 8 inch piece bent around 3/4ths in with a 2 inch pipe bend
Should work perfect methinks.. looks sorta funny not being able to put them where they should be
lol
Not too shabby. to secure it even more I think I will pull a Shne and get some angle irion to block the front of it.. that way no one can get a clamp around them to spin em.
Ohh speakin of that.. any luck looking at getting those extended brackets made by the way shane? Need to be about 2 inches wide, roughly an 8 inch piece bent around 3/4ths in with a 2 inch pipe bend
Should work perfect methinks.. looks sorta funny not being able to put them where they should be
lol
Ohh speakin of that.. any luck looking at getting those extended brackets made by the way shane? Need to be about 2 inches wide, roughly an 8 inch piece bent around 3/4ths in with a 2 inch pipe bend
Should work perfect methinks.. looks sorta funny not being able to put them where they should be
lol













