A/C & Heat not working properly
A/C & Heat not working properly
I just replaced my thermostat last weekend and the overheating issue has been remedied, but now the A/C does not blow cool air like before and the heater does not blow warm air after the engines warms up.. Any thoughts?
MAKE SURE YOU HAVE THE CORRECT TEMPETURE RATING STAT FOR YOUR TRUCK,ALSO IT SOUNDS LIKE THE COOLING SYSTEM HAS AIR IN IT WHICH WILL CAUSE YOUR HEATER NOT TO PREFORM,YOUR A/C NEEDS TO HAVE GAUGES PUT ON IT TO MAKE SURE IT'S NOT UNDER OR OVER CHARGED, OVER OR UNDER CHARGED WOULD CAUSE THE A/C NOT TO BE AS COLD,ALSO NEED TO MAKE SURE YOUR CONDENSER FAN IS WORKING GOOD
OK.. let me rephrase the question.. is there any air left in the cooling system??
there..is that better,would you like your lollipop now??
but bring it to a shop for an a/c diag. first check if your compressor turn on at all. if it doesnt report back.
MAKE SURE YOU HAVE THE CORRECT TEMPETURE RATING STAT FOR YOUR TRUCK,ALSO IT SOUNDS LIKE THE COOLING SYSTEM HAS AIR IN IT WHICH WILL CAUSE YOUR HEATER NOT TO PREFORM,YOUR A/C NEEDS TO HAVE GAUGES PUT ON IT TO MAKE SURE IT'S NOT UNDER OR OVER CHARGED, OVER OR UNDER CHARGED WOULD CAUSE THE A/C NOT TO BE AS COLD,ALSO NEED TO MAKE SURE YOUR CONDENSER FAN IS WORKING GOOD
Thread
Thread Starter
Forum
Replies
Last Post
Vince near Seattle
Interior Semi-Tech
1
Oct 31, 2009 08:53 PM
Chattanoogan
General Technical & Electrical
3
Oct 31, 2009 08:50 PM
Fx4wannabe01
Ranger-Forums Office
12
Jun 5, 2009 12:58 PM





![104[1]](https://www.ranger-forums.com/rf/forum2/images/smilies/104[1].gif)
