4.0L OHV & SOHC V6 Tech General discussion of 4.0L OHV and SOHC V6 Ford Ranger engines.
View Poll Results: Need help
Help
0
0%
Any ideas
0
0%
Multiple Choice Poll. Voters: 0. You may not vote on this poll

4.0 won't start help

Thread Tools
 
Search this Thread
 
Old Sep 6, 2022
  #1  
McCaslin's Avatar
Thread Starter
|
Member
Joined: Sep 2022
Posts: 1
Likes: 0
From: Colorado Springs
4.0 won't start help

Ok hello I am new here so beat with me thanks ! My problem is I was driving my truck and it seemed to die but it still was idling so I was close to the house I coasted home still idling but I put my foot on the pedal and it would die out take it off and it would idle ? So I put my code reader on it it said detected misfires and IAC was bad ? I change plugs and wires and got a brand new IAC put it on , now she cranks but won't start ?? I apologize I have a 1996 ford ranger xlt ex cab 5 speed tranny two wheel drive . I am in need of help the truck is the way I make a living , so if someone could help me I want to thank you
 
Reply
Old Sep 6, 2022
  #2  
2011Supercab's Avatar
Member
Joined: Jun 2018
Posts: 2,358
Likes: 391
From: Everett, WA
Originally Posted by McCaslin
So I put my code reader on it, it said IAC was bad
What was the code ? P0000

There is no code that says bad IAC
 
Reply
Old Sep 6, 2022
  #3  
RonD's Avatar
RF Veteran
iTrader: (1)
Joined: Jan 2014
Posts: 30,635
Likes: 2,949
From: Vancouver, BC
Welcome to the forum

+1 on the bad IAC Valve code, no OBD codes can ID a bad part, just bad signals or intermittent signals

In any case it reads like you were losing fuel pressure, dirty fuel filter maybe

And could have a leak in brake power booster, but not why it won't start now

Do 50/50 test
Spray fuel into the engine, gasoline, quick start(ether), carb cleaner, ect...............
Try to start
If it starts, runs and dies, then you have good spark but no fuel flow from injectors
If it doesn't start then you have no spark
50/50 instant results on what to check next, no guessing


When you first turn on the key you will HEAR the fuel pump run for 2 seconds and then shut off, its not quiet
Repeat key off and then on as much as you like to HEAR if fuel pump is working


When you turn on the key the CEL(check engine light) will come on, that means computer has Booted Up
When engine starts to turn, cranking, the CEL should go OFF, that means computer is getting a good timing signal from Crank Sensor so will start spark and then open fuel injectors

You can also crank engine over a few times then pull out ANY spark plug, its tip should be WET with fuel, if its DRY then no fuel is making it into the engine
It spark plug tip is WET, light it with a match or lighter, should burn easily, if not there is NOT gasoline in your tank, its something else, if you just got gas prior to this then you got some "bad" gas, has water in it, it happens
Engine would misfire, and barely run, and would not restart once it was cold, so could fit your description
 

Last edited by RonD; Sep 6, 2022 at 12:59 PM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Chucky19977
SOHC - 2.3L & 2.5L Lima Engines
1
Dec 21, 2020 05:55 AM
UNCLEJODGE
2.9L & 3.0L V6 Tech
1
Jul 9, 2014 08:28 PM
xhosebx1054
4.0L OHV & SOHC V6 Tech
3
May 27, 2011 08:50 PM
aiezzi
2.9L & 3.0L V6 Tech
1
Sep 23, 2008 07:03 PM
Trophy_Ranger
General Technical & Electrical
3
Nov 28, 2007 07:53 AM




All times are GMT -6. The time now is 01:44 AM.