i am trying to put my t-bars back to stock torque. does anyone know the length of the bolt. i mean the amount showing to where you can measure it??? i tried looking on here and on TRS. any ideas??????

Thanks
Kris

 

15 turns after bolt seats on the Key..

 

so 15 complete 360 turns not just 90 degree ????

there is no measurment or so ???

 

from the center of the control arm bolt to the lowest point on the spindle should be 4.56"

 

There really isn't any way to put it back to factory spec by just measureing the adjustment bolt....mostly due to tbar wear/sag. What you can do is set it up to factory spec ride height. See below:



Diagram pulled from '01 manual.

 

thanks that chart would help if i didnt have a lift lol i guess i will just have to find a 4.0 ranger on t bars and measure it lol

 

It stil applies.... you've just got a spindle lift, your end measurements will be the same as ford's spec.

Ground to bottom of knuckle = measurement a
Ground to center of LCA bolt = measurement b
Measurement B minus measurement A = ride height as show in the chart. It doesn't change with a spindle lift.

 

yes 360 turns why would you assume 15 turns to be only half a turn?