Goodbye Power Wagon, Hello King Ranch
Joined: Feb 2007
Posts: 5,022
Likes: 1
From: Midland, TX
Change of plans. The 30" bar is a little too big to get the bar where I want it. The light fits but with the mounts and power cord is a too long. So I'm going to send these back and go with 2 20" bars instead.
These were my options and I didn't like either way
Too far in

Too far out
These were my options and I didn't like either way
Too far in

Too far out
Joined: Feb 2007
Posts: 5,022
Likes: 1
From: Midland, TX
Well I said *** it after I looked at a couple pics I had seen of people installing 30" bars and they were in the same placement. So I made some mounts to see how it would shine thru. Very bright but I put the spot instead of the fog at the bottom. So I need to switch it.
Shitty phone pic
Shitty phone pic
Joined: Feb 2007
Posts: 5,022
Likes: 1
From: Midland, TX
Well I swapped the spot bar out for the flood bar. Not bad for a fog light. Hopefully tomorrow I can install the spot bar on top and get some real pics. Here's these for now
Headlights on low

Headlights on low and flood bar (damn my windshield is dirty)
Headlights on low

Headlights on low and flood bar (damn my windshield is dirty)
Joined: Feb 2007
Posts: 5,022
Likes: 1
From: Midland, TX
The bottom fog light has been off due to clearance issues with the condenser. I think I can shave a piece of the back housing down to clear but haven't decided if I want to do that just yet or not. So I was waiting to take some when I had both on.
Joined: Feb 2007
Posts: 5,022
Likes: 1
From: Midland, TX
Haven't done much lately other than work out of it. I did install a dash cam that you can see behind the rear view mirror in the second pic. I'm about to order a 2.5" lift from carli though. With some 295/65/20 nittos which are 35.5". Should look good but still be manageable to work out of. Couple muddy working











