My 53 F-100

ROFL You've got jokes! I think its good the way it is. Easy to load/unload the 4-wheeler, lumber, trees, or whatever the hells back there.
The "header panel" at the front of the bed is off a 51 IIRC. I BELIEVE it's the original bed, but I can't say for sure. I bought it the way it sits. Under the hood is a 350 SBC, 700R4 trans, and IIRC it's a GM Corp 10 bolt rear end with 2.56 gears. It's slow off the line but it cruises at 60-70 mph nicely.

I used to drive the hell out of it. It needs some TLC now.
Thanks for all the kind comments fella's. Little story today....
I went to the dealership today to get a part. I walked out and a few salesmen were standing around outside. I got in the truck to leave and one of them came up and told me about the car show they were going to have. I told him I saw the sign on the door and that i'd probably be there. He asked me what engine in it and I told him it was a 350. He said, "oh, a Cleveland?". I tried so hard not to laugh as I said "No, it's a chevrolet". He walked off after that....what a dumbass.
I went to the dealership today to get a part. I walked out and a few salesmen were standing around outside. I got in the truck to leave and one of them came up and told me about the car show they were going to have. I told him I saw the sign on the door and that i'd probably be there. He asked me what engine in it and I told him it was a 350. He said, "oh, a Cleveland?". I tried so hard not to laugh as I said "No, it's a chevrolet". He walked off after that....what a dumbass.
Ya right!
Ya. I quite like it where it is though. Most around here who have these (not many) have them swapped under the bed with a little cap to fill it up there. For as much as I will start driving it again, that's too much of a hassle. Speaking of the bed, i'll have to take pictures of it. It's a solid oak bed!












