Seats, Light Bars, and Exhaust
#1
Seats, Light Bars, and Exhaust
Just got my truck's seats covered in high quality marine vinyl for Christmas. Ridiculously soft and sturdy too. I am greatly pleased! Second, I had ordered a light bar from Underdog-Performance, but that deal fell through b/c the owner's truck that he usually uses to get correct measurements was involved in a fender bender. So he sent me two light tabs for free. And thirdly, I took off my Delta 40 Series Muffler and replaced it with a Flowmaster 10 Series. Now to the pics, 56K Beware...
#2
#8
Ok video will come asap! (prob after Christmas weekend). However thanks for the comments guys!
He had to fix my driver seat. The left side of the seat at the bottom (where your butt sits), was like totally flat. So the upholster went back and put the strongest foam he could find in that area and it sits so much better!
He had to fix my driver seat. The left side of the seat at the bottom (where your butt sits), was like totally flat. So the upholster went back and put the strongest foam he could find in that area and it sits so much better!
#10
good to hear they did you right. the quality looks good as well. that's standard for any seat repair we make. fix the foam and add a little extra protection on the bottom as well.
#11
#12
#14
Well since you are the second person that has said that, I better get that looked at asap, lol. That will be an expensive fix though I'm thinking. Yeah man regardless of if I get the exhaust fixed or whatever happens, I will get a sound clip up as quickly as possible.
#15
I appreciate it man! However to answer your question, they are not covers. That is actual high quality vinyl that replaced the cotton tweed that was on the seats before. The upholstery guy that I used stripped off all of the old cray tweed. Then he rebuilt the foam on the driver seat. After that he wrapped the stock seats with the black and dove grey two tone vinyl. Expensive...yes. Worth it...most definitely!
#17
#18
#19
^I gotcha man. Yeah I would def recommend doing what I did. The quality is intense. And when he was putting on the vinyl, the middle console deal was broken all to pieces including the latch. So we went and got some 1/2" MFD board, sanded it, and placed it as the new lid, and attached the latch someway with some hardcore glue. Then preceded to wrap it with the vinyl. My center console has never been this sturdy. Even since the first day that I got the truck.
Last edited by Jelly's Ford; 12-26-2010 at 11:59 AM.
#20
Here's a video taken by a Flip camera. Ok quality, but I will post a better video as soon as I can get my video editing software going good.
Youtube Video: YouTube - tenors2's Channel
Youtube Video: YouTube - tenors2's Channel
#24