Hi I have a 1994 Ford Ranger with the 2.3 and it is giving me these codes (key on, engine off). Can someone point me in the direction I should go to fix it?


539 (O) System shows voltage at PCM pin 10. Is A/C on (it was on)
181 (M) Fuel system was lean at part throttle Single, Right or Rear HO2S
223 (M) Dual Plug (DPI), SPOUT or IDM circuit fault
224 (M) Failure in ignition coil primary circuit
452 (M) Vehicle Speed Sensor (VSS) problem

Thanks so much

 

Is the truck still running?

 

Yep. Runs and drives. Just has the check engine light on and misfires every once in a while. Also the speedo does not work.

 

Ill be surprised if youll get any help back. I posted a thing about codes too and noone really is helping with the scenario. Best of luck!

 

I am having the same issue but i see no response here either.

these are my codes
code 90 is a cylinder balance test failure, dtc 224 is a primary ignition fault, dtc 998 Hard fault code.