i installed my flywheel and a new clutch disk on my 93 ford ranger and well now went i put my tranny back in and went to install my gear pole back well its like my transmission is locked up and i can't even shift into no gear and i started my truck up the flywheel and clutch worked fine another thing is though my clutch feels real light and it always felt a lil hard to push in then what it is now. and i bleed the clutch and its the same thing i have no idea what is wrong why i cant get nothing to go in gear now.. any advice would be nice... thnx alot!

 

im not sure why you can't get it in gear i never had that problem but your clutch will never be a lil hard to push again bc i have bleed mine several times trying to get it hard again and nothing.

 

anything to do with Hydralics which i belive my clutch is?

 

does it go into gear with the engine off?

 

Good call Jason, you beat me to it.....haha.

Sounds like air in the system still.




Allen

 

i figured it out.. i stuck a Chizzle in the hole where the pole goes and popped the pin over and now it's fine!