My Dana 30 Build Thread
#28
When I get back in town ill take photos of it. The lower bump stops are 3" bodylift pucks some steel and a bolt, the uppers are ACOS's.
#30
#31
Join Date: Jun 2007
Location: Phoenix, AZ
Posts: 1,462
Likes: 0
Received 0 Likes
on
0 Posts
#35
Join Date: Jun 2007
Location: Phoenix, AZ
Posts: 1,462
Likes: 0
Received 0 Likes
on
0 Posts
#37
Join Date: Jun 2007
Location: Phoenix, AZ
Posts: 1,462
Likes: 0
Received 0 Likes
on
0 Posts
I remember seeing the swap somewhere BUT i wasnt really intending on doing it. I cant remember where I read the article but what is the advantages of the brake swap?
EDIT: I remembered I saved this link in my favorites while doing research. Is this the same thing you're talking about?? If this is the case, Ill probably leave this for another project at a later time because I dont really want to start another project within a project, especially when I already have all the parts for the original project that im doing lol... So this brake upgrade will be considered when its time to do the front brakes again.
http://www.therangerstation.com/foru...&highlight=d30
EDIT: I remembered I saved this link in my favorites while doing research. Is this the same thing you're talking about?? If this is the case, Ill probably leave this for another project at a later time because I dont really want to start another project within a project, especially when I already have all the parts for the original project that im doing lol... So this brake upgrade will be considered when its time to do the front brakes again.
http://www.therangerstation.com/foru...&highlight=d30
Last edited by MudSlanger; 09-25-2012 at 01:57 AM.
#38
Join Date: Jun 2007
Location: Phoenix, AZ
Posts: 1,462
Likes: 0
Received 0 Likes
on
0 Posts
#40
Join Date: Jun 2007
Location: Phoenix, AZ
Posts: 1,462
Likes: 0
Received 0 Likes
on
0 Posts
I'm hoping I'll have it all finished a couple weeks before thanksgiving weekend. I still have to cut the brackets off the pass side still, Ill take care of that tomorrow. Once thats done, I can start welding and bolting everything in place. My biggest thing right now is figuring out where this axle is going to sit permanently. Any suggestions??
#41
I'm hoping I'll have it all finished a couple weeks before thanksgiving weekend. I still have to cut the brackets off the pass side still, Ill take care of that tomorrow. Once thats done, I can start welding and bolting everything in place. My biggest thing right now is figuring out where this axle is going to sit permanently. Any suggestions??
#50