4 Lift Kit for 4WD fit a 2WD Ranger?
Thread Starter
|
Member
Joined: Feb 2019
Posts: 20
Likes: 0
From: Tuskegee, al
4 Lift Kit for 4WD fit a 2WD Ranger?
I have a 1999 Ford Ranger thats a 2WD and just so happen to have a 4WD.
my question is will this work with my ranger?
Features:
The lift kit retains factory ride quality, steering geometry, and CV axle angles. All load-bearing bracketry is laser-cut from .25" steel plate.
This replacement steering knuckle lift includes lower control arm crossmembers, plus bracketry to lower the torsion bar crossmember.
A 3" block kit provides rear lift. The lift kit includes front and rear Superlift shocks.
NOTE: FX4 models require optional Rear U-bolt Kit part #10914.
my question is will this work with my ranger?
Features:
- New nodular iron knuckles, not ball joint spacers
- Load bearing bracketry made of .25" thick plate steel or heavy-wall tubing
- Full-width differential/control arm crossmembers provide lateral rigidity
- Rear lift achieved via blocks
- Front / rear Superide shocks included
- Heavy-duty replacement front driveshaft available
The lift kit retains factory ride quality, steering geometry, and CV axle angles. All load-bearing bracketry is laser-cut from .25" steel plate.
This replacement steering knuckle lift includes lower control arm crossmembers, plus bracketry to lower the torsion bar crossmember.
A 3" block kit provides rear lift. The lift kit includes front and rear Superlift shocks.
NOTE: FX4 models require optional Rear U-bolt Kit part #10914.
Thread
Thread Starter
Forum
Replies
Last Post
