Fabtech 3" Lift Questions
#1
Fabtech 3" Lift Questions
Im looking into buying the fabtech spindle lift.
The alignment cam and bolt kit is that something you do after your all done or do you take that to a alignment shop and they use the hardware to align the truck.
Also it says
"Use 32/11.50R15 tire w/15x7 wheels w/3 3/4" BS w/minor trimming"
I allready have 16" rims so will I be fine with the wheels I have?
The alignment cam and bolt kit is that something you do after your all done or do you take that to a alignment shop and they use the hardware to align the truck.
Also it says
"Use 32/11.50R15 tire w/15x7 wheels w/3 3/4" BS w/minor trimming"
I allready have 16" rims so will I be fine with the wheels I have?
#2
you should be fine with the wheels you have now... how are your ball joints? if they are not new you should replace them while you have everything apart... the cam bolts are something you should do while you install the spindles... they go in where the upper control arm bolts to the frame and the UCA must be removed when you replace the upper ball joint
Thread
Thread Starter
Forum
Replies
Last Post
bmx4life
OLD - Suspension, Tires, & Wheels
11
05-13-2009 03:23 PM
ranger882
General Ford Ranger Discussion
11
12-03-2006 07:34 PM