I have a coil sprung and looking at spindle lifts. What kind of backspacing do I need to avoid having to do spacers? Was a camber kit needed?

I'm looking at these. Any thoughts?
http://www.ebay.com/itm/360384181415...ht_4266wt_1037

 

I ran the Cragers on mine and it said they wouldn't fit. I don't remember the backspacing but It was the Fabtech lift.

 

Have any thought about those ones I linked? They seem ok.

 

Thats the old doetsch spindles I believe. I think there companies merged. They are good.

 

That's what I have been readin. Only other thing is if I need to order a camber kit or not.

 

I didn't have one on mine.

 

Good, means I can save money. Well, guess I am gonna order me some spindles here in a few weeks.

 

I have the Doetsch spindles and I got near perfected alignment in stock setup. Its just a little off. A camber/caster kit would make it perfect. No biggee though.

I run Eagle Alloy 058s which stick out a tad further than Cragers. I ran a Crager Soft 8 spare as well.

 

call and ask? 1-877-853-2627 i just bought spindles from them, good communication

 

I messaged them a while back and they got back to me yesterday. Said the max backspacing is 4.5" and mine is only 3.625" so I'm good to go there.

 

go to napaonline.com to get your camber kit. I bought mine there, dude at firestone said it was good.