spinlde installation questions
#1
spinlde installation questions
I bought a used set of fabtech spindles off a member on here lil bit ago. I noticed fabtech's instructions have a part list with a bunch of harware. Can I not reuse my factory hardware to install them? I plan on replacing cotter pins but hoping I can reuse my bolts.
I also bought some #1 bars to install at the same time. From what i read i wont have any problems except allignment. I plan on buying the camber kit, so other than that will I be good?
For leveling the rear will just a AAL and chevy shackle do the trick?
I also bought some #1 bars to install at the same time. From what i read i wont have any problems except allignment. I plan on buying the camber kit, so other than that will I be good?
For leveling the rear will just a AAL and chevy shackle do the trick?
#2
#4
You can reuse all your old hardware, except the cotter pins but you already know that. It is suggested to use new castle nuts but I never do. I'd suggest replacing all your wheel bearings, seals, washers, nuts, and dust caps(spindle wheel bearing stuff) while installing the new spindles.
AAL and Chevy 2" drop shackle will get you about 1.5" lift out of each.
AAL and Chevy 2" drop shackle will get you about 1.5" lift out of each.
#5
Thread
Thread Starter
Forum
Replies
Last Post
heaton84
General Ford Ranger Discussion
4
04-26-2007 05:58 PM
n3elz
Suspension Tech
10
06-21-2005 08:08 AM