i went to crank my t bars today to bring the front end up a little bit and i realized the tbar on the passenger sides bolt was shorter(i assumed its already been cranked) than the drivers but the truck sits perfectly level. any suggestions to as why its like this. o yea i didnt crank them till i figure out why its like this thanks guys

 

No Ideas? do u think its alright to still crank em atleast if i keep them even

 

Just measure all four sides and crank a lil, drive around for 10-15mins and try to go over some bumps, come back and if its not where you want it to be crank a lil more. Repeat until you get where you want the front to be.

 

one bolt is longer than the other. mine are the same way. just crank em up and measure with a tape measure from ground to top of your fender, make both sides the same height.