2001 2.5L Oil Pressure Sending Unit Thread Size?
#1
2001 2.5L Oil Pressure Sending Unit Thread Size?
I would like to add a aftermarket oil pressure gauge to my truck. In do so I also want to keep the one on the dash working as it normally would. I will just Tee off the head install the factory sending unit on one size and the aftermarket on the other. I would like to do all the fittings need before I start so I need to know the thread size for the sensor.
Thanks
Wayne
Thanks
Wayne
#2
RF Veteran
iTrader: (1)
Go to the auto parts store, they will have all the fittings needed.
Have them pull out a replacement oil pressure switch for your year/engine.
And pull out a PS60 universal oil pressure sender.
Then you can find the fittings you need, there is often not alot of room around the oil pressure switch so take a picture of where it is or better yet have the truck there so you can eyeball any issues
Picture here: http://www.therangerstation.com/foru...d.php?t=140811
Drawing here, 2001 and earlier 2.3l and 2.5l are the same: http://repairguide.autozone.com/znet...3f8021b7e1.gif
Have them pull out a replacement oil pressure switch for your year/engine.
And pull out a PS60 universal oil pressure sender.
Then you can find the fittings you need, there is often not alot of room around the oil pressure switch so take a picture of where it is or better yet have the truck there so you can eyeball any issues
Picture here: http://www.therangerstation.com/foru...d.php?t=140811
Drawing here, 2001 and earlier 2.3l and 2.5l are the same: http://repairguide.autozone.com/znet...3f8021b7e1.gif
Last edited by RonD; 10-02-2016 at 03:42 PM.
Thread
Thread Starter
Forum
Replies
Last Post
pbcanney
4.0L OHV & SOHC V6 Tech
10
03-20-2018 04:53 PM
FRXLT
2.9L & 3.0L V6 Tech
29
01-31-2012 10:05 AM