Accessing the timing cover: what do/don't you HAVE to remove? (OHV)
#1
Join Date: Mar 2009
Location: 559, CA
Posts: 1,174
Likes: 0
Received 0 Likes
on
0 Posts
Accessing the timing cover: what do/don't you HAVE to remove? (OHV)
My truck (4.0 OHV) has the timing cover gasket leak. I'm putting in a new water pump when I change the timing gasket. I know removing the radiator gives you alot of room to work.
People mention removing the harmonic balancer and the crank pulley. Is this REQUIRED or optional for accessing the timing cover? Ive heard that both the balancer and CP can be a bitch.
If its required then I will get a new crank seal for good measure.
If removing the balancer is required, does anyone have the part number for the OEM torque to yield bolt? And what's the torque spec on it?
People mention removing the harmonic balancer and the crank pulley. Is this REQUIRED or optional for accessing the timing cover? Ive heard that both the balancer and CP can be a bitch.
If its required then I will get a new crank seal for good measure.
If removing the balancer is required, does anyone have the part number for the OEM torque to yield bolt? And what's the torque spec on it?
Last edited by gts007; 01-26-2012 at 11:26 PM.
#3
µ 3. Install a new bolt and the washer.
l Tighten the bolt in two steps.
1 Tighten to 40-50 Nm (30-37 lb/ft).
2 Tighten an additional 80-90 degrees.
Only part numbers I see are for the special tools ford has for this.
Crankshaft Damper Remover
303-101 (T74P-6316-A)
Crankshaft Seal Replacer/Cover Aligner
303-335 (T88T-6701-A)
l Tighten the bolt in two steps.
1 Tighten to 40-50 Nm (30-37 lb/ft).
2 Tighten an additional 80-90 degrees.
Only part numbers I see are for the special tools ford has for this.
Crankshaft Damper Remover
303-101 (T74P-6316-A)
Crankshaft Seal Replacer/Cover Aligner
303-335 (T88T-6701-A)
Thread
Thread Starter
Forum
Replies
Last Post
ringer4x4
OLD - Interior, Exterior, Electrical, & Misc.
0
07-22-2009 06:51 PM
KnightRider
Interior Semi-Tech
13
08-18-2005 11:39 AM