Replacing a slave cylinder
#1
#2
#3
#7
I didnt know if the slaves were outside or inside, because i had to swap the slave cylinder on my car back in the day and it took like 30 min....but since its on the inside, i would DEFF put in a new clutch and get the flywheel resurfaced, or you will be in the same situation in a year or so....Exspecially if you drove it home with no clutch...
Rocky
Rocky
#10
Mine I think has been acting up on me too. I have a little under forty thousand on my truck and I am really not that excited to pay for that. I just had the one in my plow truck (explorer) replaced and it was an $800 bill. If I didn't think the 06's were butt ugly I would trade it in, This truck is slowly becomeing my hard luck truck. I have been lucky until this truck, the only thing I replaced in 80,000 miles on my 01 was the front diff seal. so far this truck has cost me around $1500 in stupid repairs including everything on the rear brakes repaired. I think it might be a sign to get out of this truck. I usually trade in every two years but I held onto this one, because it had so low of miles. I used to do 40,000 miles a year. now I am down to 20,000.
~HJ
~HJ
#12
hey i just had my slave and master crap out on me on friday with 146k km on my truck got the slave replaced with a aftermarket one a new clutch and pressure plate since my clutch only had about 20% left. i woulda done the job by my self cept it died on the coldest day of the winter so far -33deg celcius so i had to take it in. well it ended up costin me $1532.90 cnd
#13
#15
Morph, yours sounds like the master is acting up, mine did the same. Engage low this at that temp middle here there, then high driving a while, then gave up in the morning.
That was a 52,7xx now have 53,2xx and I find that I am losing clutch fluid. Sure enough the slave is wet looking and there is fluid all around the holes in the transmission. I wonder how long it will last before it pukes? Grrr
That was a 52,7xx now have 53,2xx and I find that I am losing clutch fluid. Sure enough the slave is wet looking and there is fluid all around the holes in the transmission. I wonder how long it will last before it pukes? Grrr
#17
Thread
Thread Starter
Forum
Replies
Last Post
lifted97ranger
Drivetrain Tech
21
01-17-2014 10:38 PM