2011 bedliner what years will fit?
#1
#2
#4
Thanks, guys,
I got the one on offerup.
Now, there is no hardware. Any mounting tips?? It has holes at the tie down locations in front and rear. Also there are 3 round holes on sides at front , middle and rear. I'm just wondering if there is or had been any mounting kits for these?
I found these at Ford sight. VAC3Z-99000A64-B they are tie down anchors that fit in the square holes on top of the bed rails.
Thanks,
troy
I got the one on offerup.
Now, there is no hardware. Any mounting tips?? It has holes at the tie down locations in front and rear. Also there are 3 round holes on sides at front , middle and rear. I'm just wondering if there is or had been any mounting kits for these?
I found these at Ford sight. VAC3Z-99000A64-B they are tie down anchors that fit in the square holes on top of the bed rails.
Thanks,
troy
#7
Moderator
iTrader: (1)
There was some type of plug assembly that pushed into those three holes on each side of the liner. If I recall correctly, they gripped onto the bottom lip of the bed rail and that's what kept the liner from flying out.
I can't seem to find them anywhere, which isn't surprising since they were usually part of the entire bedliner assembly. Short of calling your local dealer's parts department (they probably won't know what you're talking about), your only option to find these plugs would be to find them from a junkyard truck.
I can't seem to find them anywhere, which isn't surprising since they were usually part of the entire bedliner assembly. Short of calling your local dealer's parts department (they probably won't know what you're talking about), your only option to find these plugs would be to find them from a junkyard truck.
#8
Thread
Thread Starter
Forum
Replies
Last Post
93-danger-ranger
General Ford Ranger Discussion
10
11-15-2010 02:54 PM