all gauges not working
#1
all gauges not working
hi all,
im new here, just bought 94 ranger 3.0 v6 manual, 4x4.
problem- all gauges are not working.
i read through the threads and tried a couple of things but am no closer to solving problem
with the single wire disconnected from the water temp sensor and the oil pressure sensor, and the engine running, i have zero volts measured at the wire.
oh yah, tried grounding the wire also, gauges did not move.
i believe that there is a common problem to all the gauges but i dont have a wiring schematic to follow.
perhaps a common ground or power supply maybe.
all fuses are ok, lights on dash cluster work, all small lights to indicate troubles all seem to work. i read somewhere that there is a power supply for the gauges but dont know where it is.
any ideas?
any one know where to get wiring schematics for this model
thanks in adance
nick
im new here, just bought 94 ranger 3.0 v6 manual, 4x4.
problem- all gauges are not working.
i read through the threads and tried a couple of things but am no closer to solving problem
with the single wire disconnected from the water temp sensor and the oil pressure sensor, and the engine running, i have zero volts measured at the wire.
oh yah, tried grounding the wire also, gauges did not move.
i believe that there is a common problem to all the gauges but i dont have a wiring schematic to follow.
perhaps a common ground or power supply maybe.
all fuses are ok, lights on dash cluster work, all small lights to indicate troubles all seem to work. i read somewhere that there is a power supply for the gauges but dont know where it is.
any ideas?
any one know where to get wiring schematics for this model
thanks in adance
nick
Thread
Thread Starter
Forum
Replies
Last Post
stevie
General Technical & Electrical
34
06-20-2015 08:42 AM