01 ranger 4x4 control module
#1
01 ranger 4x4 control module
Hi! new to the forum. Can't seem to find a good part number for my 2001 ranger 4x4 transfer case shift control module. The one that's on the module is no good. Checked with the local Ford dealer and they wanted over $300 for one and the parts guy wouldn't give me the replacement number. I'm sure I could find one on line cheaper. Guess they want me to pay for a diagnostic and have their service dept. install it.
#3
Member
iTrader: (2)
Join Date: Nov 2008
Location: Canada
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
I had the same problem with my '99 so I went on eBay and bought one of these
95 96 97 98 99-04 Ford Ranger Transfer Case Shift Motor : eBay Motors (item 130357069862 end time Mar-07-10 06:39:43 PST)
It comes with a 1 year warranty and my works flawlessly.
Sean
95 96 97 98 99-04 Ford Ranger Transfer Case Shift Motor : eBay Motors (item 130357069862 end time Mar-07-10 06:39:43 PST)
It comes with a 1 year warranty and my works flawlessly.
Sean
#4
#6
Member
iTrader: (6)
Join Date: Jan 2007
Location: Waynesville n.c
Posts: 1,993
Likes: 0
Received 0 Likes
on
0 Posts
oh dude im still trying to figure out how you put a 00 4x4 cm on a 01??? thay wont work in a 00 their in the gem behind the radio. the 4x4 doesnt have a seperate computer like a 01 to 03 has. their a common thing to go out on em year trucks. check the salvage yards i picked one up for my friends 02 ranger for 100.00
#7
#9
#10
Actuator motor replaced and now no 4x4 lights
My 01 has a new actuator module, the 4x lights illuminate, but it will not kick into 4 wheel as no lights activate. It toggles back and fourth four or five times before timing out (?). This will occur even if I shut ignition off. Symptoms before new motor installed were typical of a failing motor with occasional difficulty switching to 4 wheel getting progressively worse. The "toggleing" is new since the new motor actuator was installed. Swapped it out for different module (? out of box failure) with same outcome. Bad ECM do you think? New battery last year. ?????
Thread
Thread Starter
Forum
Replies
Last Post
lsf53
General Technical & Electrical
2
06-02-2010 04:30 PM