How do you remove the jack?
#1
How do you remove the jack?
Hello, this is my first post on these forums, but I have been doing mods to my ranger for a little while.
I am trying to install a sub box behind my seats and need to remove the jack. I have all of the parts of the jack removed, except the large (about 3" long) bolt that comes straight out of the ground.
It appears to be spot welded to the underside of the chassis. Is there a good way to get this out? All I could think of was to hack saw it off, then grind it down.
I have a '97 standard cab ranger.
Thanks in advance.
I am trying to install a sub box behind my seats and need to remove the jack. I have all of the parts of the jack removed, except the large (about 3" long) bolt that comes straight out of the ground.
It appears to be spot welded to the underside of the chassis. Is there a good way to get this out? All I could think of was to hack saw it off, then grind it down.
I have a '97 standard cab ranger.
Thanks in advance.
#15
If only I could... The bolt runs right into my sub. And im no expert, but I think if the sub has a large hole in the coil, that is a bad thing.
I'll just hack it off, and use some torx bolts to secruce it.
I'll just hack it off, and use some torx bolts to secruce it.
Thread
Thread Starter
Forum
Replies
Last Post
bmfmancini
General Ford Ranger Discussion
8
07-01-2023 10:47 AM
02FordFX4
Interior Semi-Tech
8
03-08-2005 06:49 PM