I love being board!
#1
I love being board!
So this weekend i had nothing to do and have always wanted to change the interior, you know to keep it looking fresh an all so i started pulling out the radio bezel and cupholder and while i was at it got to work on the door panels. Well after a little clean up and a couple coats of metal speck i was ready to throw it all back on. i don't think it looks that bad i mean there will be some getting used to but over all i like it the camera seemed to make the color look a little "fruitier" than it really is but it gives a good idea.
thouht it was a good time to throw some fog lights on the skidplate while i was at it. "...It's begining to look alot like christmas...."
thouht it was a good time to throw some fog lights on the skidplate while i was at it. "...It's begining to look alot like christmas...."
#5
yeah i got at it with some fairly heavy grit sandpaper and then progressed to a finer and finer one. i think i ended up with like 320 grit paper. Be sure to get all of it off, the first time through it didn't and when i sprayed the adhesion promoter, what was left of the rubber started to wrinkle and get all nasty, had to sand again and recoat, just remember use at least 2 good coats of a sandable primer to get the final surface you want. good luck and get some pics when your done
Thread
Thread Starter
Forum
Replies
Last Post
INT3RC3PTOR
General Ford Ranger Discussion
30
11-01-2005 04:34 AM
blckout
Ranger-Forums Office
33
10-07-2005 10:57 PM