Interior paint?
#2
For starters, i'm sure this will come up in this topic.
The search function will answer your question, but since i just did mine a few months back, here is what i did:
You will need :
sandpaper - Medium grit all the way to a very fine grit
Primer
Adhesion Promoter (not everyone uses it)
Clearcoat.
Your paint (they make special plastic paints, i used Duplicolor to match the outside color of my truck)
Sand down your product with a medium grit to get rid of any major flaws in the thing being painted.
Clean off with soap and water.
Then go over again with a fine grit sandpaper.
Clean off with like denatured alcohol or something to remove any finger oil.
Prime, and let dry.
Sand with a very fine grit sandpaper.
Clean off with like denatured alcohol or something to remove any finger oil.
Prime, and let dry.
Sand with a very fine grit sandpaper.
Clean off with like denatured alcohol or something to remove any finger oil.
Spray with you choice of color paint, let dry.
You may need 3 light coats. Never do heavy coats it will run and look sloppy.
Then apply a Clearcoat, and let dry for a week before putting back in.
Anyone else wanna cime in if i missed or messed something up here.
The search function will answer your question, but since i just did mine a few months back, here is what i did:
You will need :
sandpaper - Medium grit all the way to a very fine grit
Primer
Adhesion Promoter (not everyone uses it)
Clearcoat.
Your paint (they make special plastic paints, i used Duplicolor to match the outside color of my truck)
Sand down your product with a medium grit to get rid of any major flaws in the thing being painted.
Clean off with soap and water.
Then go over again with a fine grit sandpaper.
Clean off with like denatured alcohol or something to remove any finger oil.
Prime, and let dry.
Sand with a very fine grit sandpaper.
Clean off with like denatured alcohol or something to remove any finger oil.
Prime, and let dry.
Sand with a very fine grit sandpaper.
Clean off with like denatured alcohol or something to remove any finger oil.
Spray with you choice of color paint, let dry.
You may need 3 light coats. Never do heavy coats it will run and look sloppy.
Then apply a Clearcoat, and let dry for a week before putting back in.
Anyone else wanna cime in if i missed or messed something up here.
Thread
Thread Starter
Forum
Replies
Last Post
paganwars
General Ford Ranger Discussion
12
01-29-2012 01:46 PM
Tys 4x4 FTW
General Ford Ranger Discussion
49
06-11-2009 06:32 PM