Where did you go with this ?
Any luck ?
My ’03 had the side frame unbolt from the drivers seat frame, funny no one else had this.
I ended up selling my seats but not the Tracks, just unbolted those too and bolted them on to a set of Ranger Bucket from P.C.
I found out also that the passenger seats from a 60/40 setup is the same as any std bucket seat. The seat pans have all of the holes needed to swap them from passenger side to driver’s side.
Only problem that might come up is the back support section, if you want the adjustable lower back support you need to add that in.
4x4, 5sp, Std Cab, Stepside, E4 Red
4” Lift - Coil-Overs, 6” SkyJacker Leafs - No Blocks (Mistake)
31 Spline FX4 Rear Axle, 4.56s and OX Locker, Hurst Shifter w/Optional Stick and "Made by Grev" alignment adapter