Biltrites axle builds and eventual sas
#181
#187
#196
thanks
thank you
I got it from RLC welding a vendor on pirate... for a good price I might add
maybe later
#198
started doing a little fab work
got a new transfer case skid bent up out of a piece of quarter inch
and I cut one side of the radius arm frame mounts off, then trimmed the cut off sides to make nut plates
so I can mount them like this....
the plan is to weld the mounts to the skid plate. the whole thing will then bolt up
to the bottom and sides of the frame, a few bolts threw the skid plate and the 6 bolts in each mount
I figure it will be more than enough to hold, if there is ever enough force to rip the bolts out, it will rip my frame in half
this is just the start I plan on beefing it up alot more and maybe even catching my trany mount off of it
got a new transfer case skid bent up out of a piece of quarter inch
and I cut one side of the radius arm frame mounts off, then trimmed the cut off sides to make nut plates
so I can mount them like this....
the plan is to weld the mounts to the skid plate. the whole thing will then bolt up
to the bottom and sides of the frame, a few bolts threw the skid plate and the 6 bolts in each mount
I figure it will be more than enough to hold, if there is ever enough force to rip the bolts out, it will rip my frame in half
this is just the start I plan on beefing it up alot more and maybe even catching my trany mount off of it
Last edited by BILTRITE BULLIES; 04-01-2011 at 04:21 PM.