My Current Setup
#5
33's on 15x10s with -45mm offset.
Thanks dude. Give me a min to find another photo or two. I basically just used the included self tappers. They were some stout *******. I drilled pilot holes into the roof, used outdoor silicone and rubber washers. No leaks yet crossed fingers. It doesn't fit flush but that's because I'm a lazy bastard and got tired of sanding and test fitting. Good enough for me.
Thanks dude I appreciate the words. Kept it simple with 4" spindles in the front. In the rear are 3" lift blocks and a short AAL. Topped it off with a 3" body lift. Then you have the 33s. Brush guard is GoRhino 3378b .
Thanks dude I appreciate the words. Kept it simple with 4" spindles in the front. In the rear are 3" lift blocks and a short AAL. Topped it off with a 3" body lift. Then you have the 33s. Brush guard is GoRhino 3378b .
#6
Thread
Thread Starter
Forum
Replies
Last Post
FoMoCoFiddy
Snapshots
18
04-15-2008 12:06 AM